No products
Check out
You will receive one brass sliding metric caliper which is a great measuring tool for beads, settings and stampings. It is about three and a half inches long and it measures three inches and millimeters up to 80mm. #X411
You will receive six vinyl coated clips which are great for holding pieces in place while the glue sets up. They measure about two and one-fourth inches long by three-fourths inches wide so they are great for using with larger pieces. They come in bright and pastel colors. Bright colors are shown here. #X333A
You will receive one pair of steel bead tweezers. They are four inches (100mm) long and the tips are 2mm wide. These are great for picking up beads from their tiny compartments, pulling away glue bits, separating tangled chain or jump rings and many more tasks. #W60A
You will receive one hand held hole punching tool made by EuroPunch. It creates 1.8mm holes in metal. A spare bit is included. This tool has a padded handle and measures about six inches in length. #T300
This is a great tool to use with anything that comes in a tube. Just slip it over the end of E6000 glue tubes and roll up from the bottom to make the glue easier to distribute and to save on waste. Use them over and over. They are steel with a slot that will fit over the end of almost any tube. They measure three...
Available
Available
